The 101 series Snake Tray is designed for installation below a raised floor and
as a riser along vertical surfaces. Available in seven sizes, the 101 series tray can
accommodate up to 84 square inches of cable path or 860 data cables. Support
legs and mounting rings are pre-formed into the tray and require no additional
brackets to install
Part Number
Physical Dimensions
Loading Dimensions
Cable Capacity
Physical Volume
Wt
Finish
Height
Width
Height
Width
CM 101-3-8
5"
7 1/4"
3 1/2"
3"
10 1/2si 80
6 1/2#
PG/SS/PC/HD
CM 101-6-8
5"
10 1/4"
3 1/2"
6"
21 si 215
7 1/2#
PG/SS/PC/HD
CM 101-12-8LS
3/12"
17"
2 1/4"
12"
27 si 280
8#
PG/SS/PC/HD
CM 101-4-12-8-R6
11 1/2"
17"
4"
12"
48 si 480
11 1/2#
PG/SS/PC/HD
CM 101-12-8
5"
17"
3 1/2"
12"
42 si 430
8 1/2#
PG/SS/PC/HD
CM101-18-8
5 1/2"
23"
4"
18"
72 si 740
11 1/2#
PG/SS/PC/HD
CM 101-4-21-8-R6
-
-
4"
21"
84 si 860
15 #
PG/SS/PC/HD
50% FILL AS PER NEC ARTICLE 392.9B .25 OD OTHER SIZES AVAILABLE.
FINISHES PRE-GALVANIZED (PG), STAINLESS STEEL (SS), POWDERED COATED(PC), HOT DIPPED (HD)
Snake Tray manufactures innovative electrical and communications solutions that are designed to install faster and more easily than any other available cable management or power distribution products.
Snake Tray® Cable Management Solutions
Snake Tray is the fastest installing, most cost-effective cable support system available today. Its patented hand bendable design delivers advantages found nowhere else. Unlike traditional cable tray products, Snake Tray requires no cutting and no clipping allowing installers to create turns in 10 seconds – far less than the 15 minutes per turn which is typical with wire mesh cable tray products. Available in a wide array of styles, Snake Tray’s hand bendable design combined with our built-in mounting hardware installs faster delivering a cost-savings advantage over any other cable tray system in today’s market.